hedgehouse
2 posts
msg #151888
- Ignore hedgehouse |
4/24/2020 8:19:28 AM
Hello All
Is there a way to manually type in a stock symbol into stockfetcher and it will give me the scanning phrases/code/technicals of that chart?
|
xarlor
585 posts
msg #151889
- Ignore xarlor |
4/24/2020 8:32:48 AM
For the chart, all you need is to type the following:
symlist(MSFT)
I'm not sure what you mean by "scanning phrases/code/technicals." Can you elaborate?
|
karennma
8,057 posts
msg #151891
- Ignore karennma |
4/24/2020 8:56:38 AM
@ hedge,
Re: technicals
You MUST have filters.
If you're a newbie and you don't have your own filters, then, just copy some from the forums and store them.
Then, do this: (from an earlier post)
karennma
7,601 posts
msg #151825
modified 4/14/2020 9:08:14 AM
1-Go to HOME page (Click stockfetcher upper left corner).
2- Scroll down a bit and on the RIGHT hand side you'll see the instructions:
"Enter a stock symbol below to view the chart and saved filter matches:"
3-Type your symbol
So, ...
Let's say you have 250 filters.
You put in your stock symbol and SF will let you know which 250 filters match that symbol.
|
hedgehouse
2 posts
msg #151899
- Ignore hedgehouse |
4/25/2020 10:52:49 AM
Thanks to both of you
@karennma that is what I looking for. I knew I had seen it before somewhere.
|