StockFetcher Forums · General Discussion · Mac<< >>Post Follow-up
6 posts
msg #26358
Ignore dumcrief
5/1/2003 10:35:29 PM

I use RSI line 20 for reference, why do the numbers change from chart to chart when viewing "historical charts"

267 posts
msg #26404
Ignore tomb
5/5/2003 4:03:45 PM


When you say that the RSI lines change on the charts, do you mean that the grid lines adjust? If so, then this a result of the plot adjusting the grid lines based on the minimum and maximum values in the plot. If you wish to see the line at 20 for each plot, you can try the following:

Fetcher[show stocks where the RSI(14) crossed below 30
and draw RSI(14) line at 20

Also, the example below is a work-around to allow your RSI plots to always be scaled from 0 to 100

Fetcher[show stocks where the RSI(14) crossed below 30
and draw RSI(14) line at 0
and draw RSI(14) line at 100

Hopefully the above helped!

Tom Support

StockFetcher Forums · General Discussion · Mac<< >>Post Follow-up

*** Disclaimer *** does not endorse or suggest any of the securities which are returned in any of the searches or filters. They are provided purely for informational and research purposes. does not recommend particular securities., Vestyl Software, L.L.C. and involved content providers shall not be liable for any errors or delays in the content, or for any actions taken based on the content.

Copyright 2022 - Vestyl Software L.L.C.Terms of Service | License | Questions or comments? Contact Us
EOD Data sources: DDFPlus & CSI Data Quotes delayed during active market hours. Delay times are at least 15 mins for NASDAQ, 20 mins for NYSE and Amex. Delayed intraday data provided by DDFPlus

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.